Sheet Metal Helper Level 2

POSITION SUMMARY

The Sheet Metal Helper Level 2 supports journeyman sheet metal workers, leadmen and foremen on travel-based construction projects. This position is intended for candidates with hands-on sheet metal, insulation or panel installation construction experience who can perform basic trade-related tasks with moderate supervision.

This role assists with insulation installation, insulated metal panel installation, flashing, trim, siding, material handling, layout support, fastening, sealing and other non-HVAC sheet metal work. The Level 2 Helper should be able to complete assigned tasks more independently than a Level 1 Helper but works under the direction of experienced sheet metal workers, foremen or project supervision.

MECO does not perform HVAC work. This position is not intended for candidates whose experience is limited to HVAC ductwork unless they also have relevant sheet metal, panel, insulation, siding, flashing or metal wall system experience.

ESSENTIAL DUTIES AND RESPONSIBILITIES

Work performed may include, but is not limited to:

Installation Support

• Assist with installation of insulation, insulated metal panels, flashing, trim, siding and metal wall systems.
• Measure, mark, cut, drill, fasten and seal materials under supervision.
• Assist journeyman sheet metal workers with panel alignment, fastening, trimming and fitting.
• Assist with custom sheet metal component installation.
• Assist with repairs, replacements or field modifications as directed.

Layout, Materials & Field Work

• Support layout and field preparation based on drawings and field conditions.
• Move, stage and organize panels, insulation, sheet metal materials, tools and equipment.
• Work from ladders, scaffolds, aerial lifts and elevated work areas.
• Coordinate with journeyman sheet metal workers, foremen, equipment operators and other trades.

Safety

• Use basic sheet metal hand tools and power tools safely.
• Maintain clean, organized and safe work areas.
• Follow all MECO, OSHA and site safety requirements, including the use of fall protection.

Documentation

• Assist with or provide information for basic jobsite requirements as directed.
• Sign off on daily timesheets and ensure time is recorded accurately.

SUPERVISORY RESPONSIBILITIES

• None.

TOOLS & EQUIPMENT

The employee is required to provide their own basic hand tools, including:

• Tape measure
• Hammer
• Utility knife
• Chalk line
• Rubber mallet
• Levels (torpedo and 2’ minimum)

QUALIFICATIONS

• Minimum of three (3) years of non-HVAC sheet metal installation experience.
• Ability to assist with measuring, layout support, material handling, fastening, sealing and installation tasks.
• Ability to safely use basic hand tools and power tools.
• Ability to follow directions from foremen, leaders and journeymen and work under supervision.
• Bilingual (Spanish)
• Ability to travel out of state for project assignments.
• Reliable transportation.
• Must be legally authorized to work in the United States.
• Ability to pass a 10-panel hair follicle drug test.

CORE COMPETENCIES

The successful Sheet Metal Helper should demonstrate safe work habits, dependability, a willingness to learn the trade, and the ability to follow direction and work well as part of a crew.

PHYSICAL AND WORK REQUIREMENTS

This position performs work on active construction sites, outdoors and in varying weather conditions, including heat, cold, noise and dust. The employee must be able to work at heights and in physically demanding environments, including from ladders, scaffolds, aerial lifts and elevated work areas, and must be able to lift at least 50 pounds individually and lift, carry, move and stage materials as required.

The position is travel-based and requires out-of-state travel for project assignments. The employee must wear required personal protective equipment and follow all site safety requirements.

Reasonable accommodations may be made to enable qualified individuals with disabilities to perform the essential functions of the position.